Kompernass A1 Bedienungsanleitung Seite 11
- Seite / 54
- Inhaltsverzeichnis
- FEHLERBEHEBUNG
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
9
Setting up and connecting
SKRD 30 A1
GB
CY
Inserting the battery
By inserting the battery you can avoid the loss of programmed time of day and
alarm times in the event of a possible power outage. The battery ensures that
the internal clock continues to run even during a power failure. When power is
restored the correct time appears automatically in the display
3
.
NOTICE
The device can also be operated without a battery. ►
Open the cover of the battery compartment ♦
19
on the underside of the
device by turning the cover to the left, with a coin, as far as it will go and
then lift off .
Insert the battery type CR2032 (supplied) into the battery compartment. ♦
The side with the marking + points upwards.
Close the batter
y compartment by attaching the cover and then with a coin ♦
turn it to the right.
Mounting under a wall cupboard
(Illustration see fold out side fi gure B)
With the supplied mounting plate you can mount the device under, for exam-
ple, a wall cupboard. For mounting of the device proceed as follows:
Press both unlocking buttons ♦
20
on the rear panel of the device downwards
thereby, at the same time, sliding the mounting plate backwards and
remove the mounting plate .
Find a suitable set-up location for the device (see also the section ♦
Requirements for the set-up location).
Hold the mounting plate ♦
under the set-up location. Thereby the front
edge of the mounting plate should be approx. 4 cm behind the front of
the cupboard so that, after Remove the mounting, the device is fl ush with the
cupboard.
Mark the 4 fastening points with a pencil. ♦
Using a spike or nail, make a small depression at the respective marking ♦
points. Screw the mounting plate
tightly with the supplied screws as
illustrated in fi gure B.
Place the device aslant, with the front recesses in the top face, in the mount- ♦
ing plate
. Press the rear part of the device upwards against the mounting
plate until the device audibly locks into place.
Check to make sure that the device is secure. ♦
- Under-Cabinet Radio 1
- Operating instructions 1
- Ugradbeni radio 1
- Upute za upotrebu 1
- SKRD 30 A1 2
- Introduction 4
- Operating components 8
- Setting up and connecting 10
- Handling and operation 13
- Cleaning/Troubleshooting 24
- Troubleshooting 25
- Storage/Disposal 26
- Appendix 27
- Autorsko pravo 30
- Uporaba u skladu sa namjenom 30
- Upozoravajuće napomene 31
- Sigurnost 32
- Opće sigurnosne napomene 33
- Element za posluživanje 34
- Postavljanje i priključivanje 35
- Posluživanje i pogon 39
- Čišćenje/Otklanjanje grešaka 50
- Otklanjanje grešaka 51
- Skladištenje/Zbrinjavanje 52
- Tehnički podaci 53
Verwandte Produkte und Handbücher für Wecker Kompernass A1
Wecker Kompernass KH 2214 Bedienungsanleitung
(16 Seiten)
(16 Seiten)
Wecker Kompernass KH 2314 Bedienungsanleitung
(29 Seiten)
(29 Seiten)
Wecker Kompernass KH 2186 Betriebsanleitung
(42 Seiten)
(42 Seiten)
Wecker Kompernass KH 2238 Broschüre
(72 Seiten)
(72 Seiten)
Wecker Kompernass KH 2295 Betriebsanleitung
(22 Seiten)
(22 Seiten)
Wecker Kompernass KH 2271 Broschüre
(51 Seiten)
(51 Seiten)
Wecker Kompernass KH 2255 Bedienungsanleitung
(12 Seiten)
(12 Seiten)
Wecker Kompernass KH 2023 Broschüre
(18 Seiten)
(18 Seiten)
Wecker Kompernass KH 2236 Betriebsanleitung
(82 Seiten)
(82 Seiten)
Wecker Kompernass KH 2001 Betriebsanleitung
(62 Seiten)
(62 Seiten)
Wecker Kompernass KH 2190 Bedienungsanleitung
(24 Seiten)
(24 Seiten)
Wecker Kompernass KH 2254 Betriebsanleitung
(14 Seiten)
(14 Seiten)
Wecker Kompernass KH 20 Broschüre
(3 Seiten)
(3 Seiten)
Geovision BL1300 manuels
Manuels d'utilisation et guides de l'utilisateur pour Caméscopes Geovision BL1300.
Nous fournissons des manuels en pdf 1 Geovision BL1300 à télécharger gratuitement par type de document : Manuel de l'utilisateur
Kommentare zu diesen Handbüchern